Plug In Refrigerator; Move Refrigerator To Final Position; Lower Leveling Legs; Install Door Panels - KitchenAid KSSC48QKS00 Instrucciones De Instalación

Plug in Refrigerator

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
1. Set control switch at top of cabinet to the OFF position.
2. Plug into a grounded 3 prong outlet.

Move Refrigerator to Final Position

IMPORTANT: To prevent floor damage, make sure levelers are
raised (not touching floor) and refrigerator is on rollers before
moving.
1. Place top of cardboard carton or plywood under refrigerator.
Remove dolly.
2. Do not remove protective film.
3. Move the refrigerator straight back and evenly into the
opening. Check to make sure that water tubing is not kinked
and power supply cord is on top of refrigerator next to the
cover.

Lower Leveling Legs

NOTE: All four leveling legs must contact the floor to support and
stabilize the full weight of refrigerator. Rollers are for moving
refrigerator and not for permanent support.
Use socket wrench to turn leg levelers on both sides of
refrigerator to the right (clockwise) until refrigerator weight is
supported by leveling legs. The rollers should be off the floor. To
avoid cabinet damage, do not apply more than 50 in./lbs.
(58 cm/kg) of torque to the leveling legs.
1. Rear leveling legs
2. Front leveling legs
1 2

Install Door Panels

Panel Models:
1. Remove all tape and door bracing from refrigerator and
freezer doors. Remove screws attaching handles to door
frame.
2. Slide decorative door panels into door frames.
3. If needed, route door panels or install a filler panel between
doors and decorative panels. See the "Custom Panels"
section.
1
2
3
1. Filler panel
2. Nylon washer
3. Door handle
4. Door panel
4. Replace door handles. Check that the top of both door
handles are aligned.
5. If door handles are not aligned, loosen all handle screws and
adjust door handles up or down. Tighten screws. If any of the
door screws are damaged, replace them with additional
screws provided in the parts package.

Level Refrigerator

NOTE: Door panels must be installed before leveling.
1. Open doors and place level on top of refrigerator frame as
shown. Check to see if refrigerator is level from left to right.
Side by Side
1
2
1. Level to check left to right leveling
2. Level to check front to back leveling
4
2
15