Using Mounting Screws; Mounting Your Controller Vertically - Allen-Bradley MicroLogix 1000 Manual Del Usuario

Installation Instructions
MicroLogix 1000 Programmable
Controllers

Using Mounting Screws

To install your controller using mounting screws:
1. Remove the mounting template
from the front of this document.
2. Secure the template to the mounting
surface. (Make sure your controller
is spaced properly.)
3. Drill holes through the template.
4. Remove the mounting template.
5. Mount the controller.
6. Leave the protective wrap attached
until you are finished wiring the
controller.

Mounting Your Controller Vertically

Your controller can also be mounted vertically within an enclosure using mounting
screws or a DIN rail. To insure the stability of your controller, we recommend
using mounting screws.
To insure the controller's reliability, the following environmental specifications
must not be exceeded.
Top A
Side Side
A
Bottom
A
A. Greater than or equal
to 50.8 mm (2 in.).
Note: When mounting your controller vertically, the nameplate should be facing
downward.
4
Description:
Operating
Temperature
A
Operating Shock
(Panel mounted)
Operating Shock
(DIN rail mounted)
Specification:
0 C to 45 C (32 F to 113 F)
9.0g peak acceleration (11 1 ms duration)
3 times each direction, each axis
7.0g peak acceleration (11 1 ms duration)
3 times each direction, each axis
Mounting
Template
Protective
Wrap
20145