Tabla de contenido
How to Set the Temperature
This water heater requires a minimum flow rate to operate. This rate can be found on the specifica on page in
this manual. In some cases when you are not ge ng hot water or if the water alternates between hot and cold,
it is due to the water flow being below or close to the minimum flow rate. Increasing the flow rate should
resolve these problems in these cases.
If you are experiencing issues with higher temperature se ngs, then reduce the temperature se ng. Selec ng a
temperature closer to that which is actually used at the faucet will increase the amount of hot water being
delivered to the faucet, due to less cold water mixing at the fixture.
DANGER
1. If the water heater is off, press
the Power bu on to turn on.
2. If the Priority light is off, then
press the "Priority Mode bu on"
on the temperature controller.
The green Priority light will glow
indica ng that this controller is
controlling the temperature and
that the water heater is ready to
supply hot water. (The priority
can only be changed while no hot
water is running.)
3. Press the up (+) or down (‐)
bu ons to obtain the desired
temperature se ng.
All hot water sources are able to
provide water at this temperature
se ng un l it is changed again at
this or another temperature
controller.
30
Hot water can be dangerous, especially for infants or children, the elderly,
or infirm. There is hot water scald poten al if the thermostat is set too high.
Water temperatures over 125° F (52° C) can cause severe burns or scalding
resul ng in death.
Hot water can cause first degree burns with exposure for as li le as:
3 seconds at 140° F (60° C)
20 seconds at 130° F (54° C)
8 minutes at 120° F (49° C)
Test the temperature of the water before placing a child in the bath or
shower.
Do not leave a child or an infirm person in the bath unsupervised.
Jacuzzi Signature Water Heaters J‐S180/J‐S199
While any hot water is being provided,
NOTICE
the temperature se ng can only be
adjusted between 98° F and 110° F.
Check local codes for the maximum water
NOTICE
temperature se ng allowed when used
in nursing homes, schools, day care
centers, and all other public applica ons.
If a newly installed unit with a controller
NOTICE
has not been powered for at least 6 hours
then the temperature will return to the
default se ng of 104° F (40° C) if power is
interrupted.
There may be a varia on between the
NOTICE
temperature displayed on the
temperature controller and the
temperature at the tap due to weather
condi ons or the length of pipe to the
water heater.
Tabla de contenido
