Tabla de contenido
Checklist to Determine Installa on
Loca on
□
The water heater is not exposed to corrosive
compounds in the air.
□
The water heater loca on complies with the
clearances.
□
For indoor models, the planned ven ng will not
exceed the maximum length for the number of
elbows used.
□
For indoor models, the planned ven ng
termina on/air intake loca on meets the
clearances.
□
The water supply does not contain chemicals or
exceed total hardness that will damage the heat
exchanger.
□
A standard 3 prong 120 VAC, 60 Hz properly
grounded wall outlet for indoor models or other
120 VAC, 60 Hz source for outdoor models is
available.
□
The installa on must conform with local codes or,
in the absence of local codes, with the Na onal
Fuel Gas Code, ANSI Z223.1/NFPA 54. If installed
in a manufactured home, the installa on must
conform with the Manufactured Home
Construc on and Safety Standard, Title 24 CFR,
Part 3280.
12
Jacuzzi Signature Water Heaters J‐S180/J‐S199
Mount to Wall
1. Iden fy the installa on loca on and confirm that
the installa on will meet all required clearances.
2. Securely a ach the water heater to the wall
using any of the holes in the wall installa on
brackets which are at the top and bo om of the
water heater. Ensure that the a achment
strength is sufficient to support the weight.
Refer to the weight of the water heater in the
Specifica ons sec on.
NOTE: The water heater should be installed in an
upright posi on. Do not install upside down or on its
side.
Remove the Front Panel
Slide the plas c trim pieces on each side of the water
heater to expose the screws.
Remove the 4 screws and pull off the front panel.
wall installa on
brackets
Tabla de contenido
