Tabla de contenido
Idiomas disponibles
Idiomas disponibles
DEBRIS SHIELD
Attach the debris shield to the gearcase with the two M6 x 30
screws as shown.
BRUSHCUTTER BLADE
A variety of metal cutting blades are available to satisfy different
cutting conditions. It is especially important to use only the correct
blade(s) approved for each model brushcutter. Also, it is especially
important to install the blade for LEFT- HAND rotation (as viewed
from the operator's position), and to correctly position all blade
holding parts (see sketch).
BEFORE OPERATION
FUEL : MIXING GASOLINE AND OIL
The two-stroke engines used in the brushcutter requires a mixture of GASOLINE and OIL for lubrication of bearings
and other moving parts. The proper fuel mixture ratio is 25 : 1, which is 40cc of oil mixed with one liter of gasoline.
NOTE : Gasoline and oil must be premixed in a clean gasoline container. Never mix gasoline and oil indoors
or in the burushcutter fuel tank. Always use fresh gasoline.
WARNING !! - NEVER USE GASOHOL OR ALCOHOL BLENDED FUELS IN MARUYAMA ENGINES.
Before filling the brushcutter fuel tank, clean around the fuel tank cap so dirt and debris does not enter the fuel
tank. Always shake the fuel container before filling the fuel tank. Remove the fuel cap, then fill the fuel tank to
within about 10mm from the top of the tank. Avoid filling the fuel tank filler neck. Install the cap securely onto
the fuel tank.
Brushcutter
Blade
Attaching
Shaft
— US-4 —
Clamp
Gearcase
Clamping
Washer
Gearcase
Hex Wrench
(4 mm)
M6×30
Screw (2)
Shaft
Assembly
Debris Shield
Blade Nut
Stabilizer
Left-hand
thread
Boss
Adapter
Tabla de contenido
