Mitre Saw; Declaration Of Conformity - Felisatti NTF250/1200ST Instrucciones De Servicio

9 PROBLEMS-CAUSES-REMEDIES
PROBLEMS
The motor fails to work
The motor starts slowly or does
not reachoperating speed.
Chipped or irregular cuts
Step cut or irregular cutting
surfaces.

MITRE SAW:

Cuts not made at the desired
angle.
UPPER TABLE:
Difficulty in cutting.
Crooked trimming.
Protective casings or moving
parts jammed.
The motor fails to start when the
starting button is pushed.
The blade stopping times lasts
longer than 10 seconds.

DECLARATION OF CONFORMITY

We hereby declare, under our sole responsibility,
that the FELISATTI brand products described in
this manual comply with the following standards or
standard documents: Standard EN 61029, Machine
Directive 98/37/EC and amendments, with 2006/95/
EC and 93/68/EEC, and in regard to electromagnetic
compatibility, with Directive 89/336/EEC, EN 55014.1,
EN 55014.2, EN61000.3.2 and EN 61000.3.3 and EN
50366.
CAUSES
Defective motor, power supply
cable or plug. Fuses blown
Low power supply voltage.
Damaged motor windings.
Condenser burnt out
The blade is dull
Inadequate blade
Worn-out or defective blade.
Inadequate squaring.
Blade – splitting wedge out of
alignment.
The guide is not parallel to the
blade.
Chips or dirt have not been
removed.
Switch malfunction.
Cables disconnected or broken.
Condenser malfunction.
Electronic module malfunction.
Jordi Carbonell
We reserve the right to make technical changes.
REMEDIES
Have the machine checked by
pecialised personnel.
Never try to repair the motor
yourself because of the potential
danger involved.
Check the fuses and replace them
ifnecessary.
Have the voltage checked by the
power supply provider.
Have the motor checked by
specialised personnel.
Have the condenser changed by
specialised personnel.
Sharpen or change the blade.
Replace the blade with a more
appropriateblade.
Change the blade.
Clean the stroke-ends.
Adjust the turntable and the
stroke-ends.
Regulate the splitting
and the protective casing fixing
bracket.
Align guide and blade.
Perform a thorough cleaning by
spraying
compressed dry air.
Contact authorised Assistance
centers.
Contact authorised Assistance
centers.
Santiago Lόpez
wedge