Recommended Hookup - Campbell Hausfeld CHN104 Instrucciones De Operación

Operating Instructions
operating The Tool
(Continued)

ReCoMMeNDeD hookUp

The illustration below shows the
recommended hookup for the tool .
1 . The air compressor
must be able
to maintain a
minimum of 60
psi when the tool
is being used . An inadequate air
supply can cause a loss of power and
inconsistent driving .
2 . An oiler can be used to
provide oil circulation
through the tool . A
filter can be used to
remove liquid and solid
impurities which can rust or "gum
up" internal parts of the tool .
3 . Always use air supply hoses with
a minimum working pressure
rating equal to or greater than the
pressure from the power source if a
regulator fails, or 150 psi, whichever
is greater . Use 1/4 inch air hose for
runs up to 50 feet . Use 3/8 inch or
greater air hoses for 50 foot run or
longer .
150 psi or greater
4 . Use a pressure regulator on the
compressor, with an operating
pressure of 0 -125 psi . A pressure
regulator is required to control
Recommended hookup
Quick
Plug
www.campbellhausfeld.com
the operating pressure of the tool
between 60 and 100 psi .
SINGle SeqUeNTIal MoDe
This mode
requires the
trigger to
60 psi
Min . be pulled
each time
100 psi
Max .
a fastener is driven . The tool can be
actuated by depressing the WCE against
the work surface followed by pulling
the trigger .
The trigger must be released to reset
the tool before another fastener can be
driven .
CheCkING The woRk CoNTaCT
eleMeNT (wCe)
Element (WCE) trip mechanism before
each use. The WCE must move freely
without binding through its entire
travel distance. The WCE spring must
return the WCE to its fully extended
position after being depressed. Do
not operate the tool if the WCE trip
mechanism is not operating properly.
Personal injury may occur.
1 . Disconnect the air
supply from the
tool .
2 . Remove all
fasteners from
the magazine
(see Loading/
Unloading) .
Quick
Coupler
Air Hose
Check the operation
of the Work Contact
Regulator
Quick Plug
(Optional)
Oiler
Quick
Coupler
(Optional)
4
3 . Make sure the trigger
and work contact
element (WCE) move
freely up and down
without sticking or
binding .
4 . Reconnect air
supply to the tool .
5 . Depress the Work
Contact Element
(WCE) against the
work surface without
pulling the trigger . The
tool MUST NoT opeRaTe . Do not
use the tool if it operates without
pulling the trigger . Personal injury
may result .
6 . Remove the tool from
the work surface .
The Work Contact
Element (WCE) must
return to its original
down position . The tool MUST NoT
opeRaTe . Do not use the tool if it
operates while lifted from the work
surface . Personal injury may result .
7 . Pull the
trigger
and
depress
the work
contact element (WCE) against the
work surface . The tool MUST NoT
opeRaTe .
Filter
Movement