Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operating Instructions
Important Safety Instructions
(Continued)
Do
not
drive a fastener on
top of other fasteners.
The fastener could
glance and cause
death or a serious puncture wound.
Do not operate or
allow anyone else to
operate the tool if any
warnings or warning labels are not
legible. Warnings or warning labels
are located on the tool magazine
and body.
Do not drop or
throw the tool.
Dropping or throwing the tool can
result in damage that will make
the tool unusable or unsafe. If the
tool has been dropped or thrown,
examine the tool closely for bent,
cracked or broken parts and air
leaks. STOP and repair before using
or serious injury could occur.
Avoid using the
tool when the
magazine is empty. Accelerated
wear on the tool may occur.
Clean and check
all air supply
hoses and fi ttings before
connecting the tool to an air
supply. Replace any damaged
or worn hoses or fi ttings. Tool
performance or durability may be
reduced.
SERVICE
a. Tool service must be performed only
by qualified repair personnel.
b. When servicing a tool, use only
identical replacement parts. Use
only authorized parts.
Recommended Hookup
BUILT TO LAST
www.chpower.com
c. Use only the lubricants supplied
with the tool or specified by the
manufacturer.
the tool without fi rst obtaining
written approval from Campbell
Hausfeld. Do not use the tool if
any shields or guards are removed
or altered. Do not use the tool as
a hammer. Personal injury or tool
WARNING
!
damage may occur.
tension from the pusher before
attempting to clear jams because
fasteners can be ejected from the
front of the tool. Personal injury
may occur.
AIR SOURCE
a. Never connect to an air source that
is capable of exceeding 200 psi.
Over pressurizing the tool is able
to result in bursting, abnormal
operation, breakage of the tool or
serious injury to persons. Use only
clean, dry, regulated compressed air
at the rated pressure or within the
rated pressure range as marked on
the tool. Always verify prior to using
the tool that the air source has been
adjusted to the rated air pressure or
within the rated air-pressure range.
b. Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
Quick Coupler
Air Hose
Do not make any
modifi cations to
Disconnect air
supply and release
Regulator
Quick Plug
Oiler
(Optional)
Quick Coupler
(Optional)
4
Do not
use any
type of reactive gases,
including, but not
limited to, oxygen and
combustible gases, as a power
source. Use fi ltered, lubricated,
regulated compressed air only.
Use of a reactive gas instead of
compressed air may cause the tool
to explode which will cause death
or serious personal injury.
Use
only
a pressure-regulated
compressed air source
to limit the air pressure
supplied to the tool. The regulated
pressure must not exceed 120 psi.
If the regulator fails, the pressure
delivered to the tool must not
exceed 200 psi. The tool could
explode which will cause death or
serious personal injury.
Operating the Tool
LUBRICATION
This tool requires lubrication before
using the tool for the first time and
before each use. If an inline oiler is
used, manual lubrication through the
air inlet is not required on a daily basis.
The work surface
can become
damaged by excessive lubrication.
Proper lubrication is the owner's
responsibility. Failure to lubricate
the tool properly will dramatically
shorten the life of the tool and
void the warranty.
1. Disconnect the air
supply from the tool
to add lubricant.
Filter
O
CO
2
120 psi
Capítulos
Tabla de contenido
