Loading/Unloading The Tool; Adjusting The Direction Of The Exhaust - Campbell Hausfeld CHN104 Instrucciones De Operación

operating The Tool
(Continued)
8 . Depress
the Work
Contact
Element
(WCE)
against the work surface . Pull the
trigger . The tool MUST opeRaTe .
An improperly
functioning tool
must not be used. Do not actuate the
tool unless the tool is placed firmly
against the work piece.

loaDING/UNloaDING The Tool

1 . Always disconnect the tool to the
air supply before loading fasteners .
2 . Push down on
the latch button .
Pull back on the
magazine cover .
3a . For nails, insert a
stick of Campbell
Hausfeld nails
or equivalent
(see "Fasteners"
section) into the
magazine . Make sure the pointed
ends of the fasteners are resting on
the bottom ledge of the magazine
when loading . Make sure the nails
are not dirty or damaged .
3b . For staples, load a clip of staples
with the crowns straddling the
magazine rail .
Magazine rail
4 . Push the magazine
cover forward until
latch button pops
up .
5 . Always unload all
fasteners before removing tool from
service . Unloading is the reverse
of loading, except that you must
disconnect the air supply before
unloading .
aDJUSTING The FaSTeNeR
peNeTRaTIoN
The tool is equipped with an adjustable
depth of drive feature . This allows the
user to determine how deep a fastener
will be driven into the work surface .
1 . Adjust operating pressure so
fasteners are driven consistently . Do
not exceed 100 psi .
2 . For shallow penetration, turn the
wheel (C) to right to the extent
desired .
Latch button
(C)
3 . For deeper penetration, turn the
wheel (C) to left to the extent
desired .
4 . Make sure trigger and
work contact element
(WCE) move freely up
and down without
binding or sticking
after each adjustment .
aDJUSTING The DIReCTIoN oF The
EXhAUSt
The CHN104 is
equipped with an
adjustable direction
exhaust deflector . This
is intended to allow
the user to change the direction of the
exhaust . Simply twist the deflector to
any direction desired .
CleaRING a JaM FRoM The Tool
1 . Disconnect the air
supply from the
tool .
2 . Remove all
cause the fasteners to eject from the
front of the tool.
3 . Undo hook by
4 . The door can
5 . Remove the
6 . Rotate door back
Movement
7 . Push button down
8 . Make sure the trigger
Rotate
5
ChN104
fasteners from
the magazine
(see Loading/
Unloading) .
Failure to remove
all fasteners will
pushing down
on the button
on the side of
the magazine .
The button will
disengage the hook from the nose .
now be rotated,
exposing the
jammed fastener .
jammed
fastener, using
pliers or a
screwdriver if
required .
into the closed
position .
again to lift the
hook . Close the
door and release
the button to
reengage the hook with the nose .
and work contact
element (WCE) move
freely up and down
without sticking or
binding .
www.campbellhausfeld.com
Built to last
Movement