Cleaning And Care; Troubleshooting - HoMedics HUM-PED1 Manual De Instrucciones E Información De Garantía

Installing Instructions
1. Remove demineralization cartridge from packaging and
let it soak in water for 10 minutes.
2. Remove the tank from humidifier base. (Fig. 3)
3. Place 1 demineralization cartridge down onto
post and into the matching slot in the humidifier
base. (Fig.9)
4. Place the tank back on the base, making sure the tank is
firmly seated. (Fig. 7)

Cleaning and Care

CAUTION: Before cleaning the unit, turn power off and
unplug unit from the outlet.
Tank Cleaning
Remove the water tank from the humidifier base by
lifting it by the handle from the main unit. Unscrew
the tank cap; wipe the tank with a soft cloth then
rinse it with clean water. (Fig. 10)
Suggestion: Clean the water tank once every two to
three weeks, depending on your water conditions.
Fig.10
Ultrasonic Nebulizer Cleaning
Put small amount of mild dish soap on the surface
of the ultrasonic nebulizer, then pour in some water
and soak for 5 minutes. Brush clean with soft bristle
brush (not included) and rinse. (Fig. 11)
Fig.11
Surface Cleaning
Clean the surface of the unit with a clean damp
soft cloth. (Fig. 12)
Fig.12
10

Troubleshooting

PROBLEM
Power Light is off
Fig. 8
SoundSpa will not
turn on
Fig. 9
Peculiar Odor
Excessive Noise
White Dust Accumulation • Hard water used
POSSIBLE CAUSE
• Unit is not plugged in • Plug unit in
• Press the POWER button
to turn the power on
• No power at unit • Check circuits, fuses, try a
different outlet
• Unit is not plugged in • Plug unit in
• Volume is down too low • Turn the SOUNDSPA
POWER/VOLUME knob
clockwise to increase
volume
• No sound selection has • Press a sound selection
been made
button to choose a sound
• Sleep Mode cycle is over • Use the SOUNDSPA
POWER/VOLUME knob to
turn the SoundSpa OFF,
then back ON again.
• If new unit • Open the water tank cap
and keep it in a shady and
cool place for 12 hours
• If unit is in use, the odor • Empty the old water,
may be a dirty tank or old clean the tank and fill
tank water with clean water
• Unit is not level • Place unit on a flat,
even surface
• Low water level • Check the water level. Refill
the tank if the water is low
• Use distilled water and a
Demineralization Cartridge
• Demineralization Cartridge • Replace Demineralization
needs replacement Cartridge
1 1
SOLUTION