Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. REMOVE GREASE DRIP RAIL
A. Lift grease drip rail to disengage it from
the bottom panel.
B. Slide grease rail all the way to the left or
1
right (
) and lift the opposite end to
disengage the other end from the bottom
2
panel (
). Remove it from the power
pack and set aside for later use.
7. REMOVE THE BOTTOM PANEL
Using a Phillips screwdriver, remove both bottom panel
retaining screws and set aside.
R
ETAINING
HO0110
8. REMOVE THE KNOCK-OUT OPENING
From inside the power pack, remove the wiring cover by removing two (2) retaining
screws and set aside. Punch out the electrical knockout hole on top of the power pack.
Install the wire clamp (included in parts bag).
9. INSTALL THE ADAPTER/DAMPER (CP34 AND CP35 MODELS)
Using (4) no. 8 x 3/8" screws from parts bag, assemble the adapter/damper on the top
of the power pack. To ensure proper opening of the dampers, remove shipping tape if
present. Seal all joints with metal foil duct tape to eliminate air leaks.
HD0291
S
L
CREW
OCATION
A
Disassemble bottom panel from power pack and set aside.
HO0111
- 6 -
B
1
2
HD0292
SIDE VIEW
HR0027
M
S
L
OUNTING
CREW
OCATION
HJ0016
Tabla de contenido
