Setting Up The Remote-Controlled Socket - Silvercrest RC DP3 0201-A DE 3726 Instrucciones De Utilización Y De Seguridad

2. Insert the round cell battery
3. Place the battery compartment
4. Press one of the ON / OFF
284705_silv_Funksteckdosen-Set_IP44_Content_ES.indd 49
with the aid of a coin or a
screwdriver, then removing the
lid (open).
type CR 2032. Make sure you
fit the battery with the correct
polarity (+ = up).
cover back on and lock it in
4
place by turning it in a clock-
wise direction (close).
buttons or to test whether
2 3
the remote control works; if it
does, the power indicator light
will come on .
1
S etting up the remote-
Q
controlled socket
(fig. B)
1. Plug the wireless socket into an
earthed mains socket. You now
have 30 seconds to complete
steps 2 and 3.
Note: Always plug in the
wireless socket in the direction
indicated on the product label
to maintain the splash water pro-
tection (arrow must point up).
Protection against water spray
is only guaranteed when a
socket of the same protection
rating (classification IPX4) is
connected.
2. Point the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
3. Push the respective ON button
of the Channel ON/OFF but-
Setting up
GB/MT 49
21.06.17 15:39