Replacing The Clipping Blades; Lubrication - Heiniger Xplorer Traducción Del Manual Original

Switch the clipper off after you have finished clipping.
‹

7.8 Replacing the clipping blades

‹
‹
‹
Abb. 10
‹
Abb. 11
Abb. 12
38
Switch the clipper off by sliding the switch to
the position "0".
Turn the adjusting knob in the direction of the
arrow until the resistance decreases.
Place the clipper with the comb plate screws
facing up onto a flat surface.
Loosen the comb plate screws and remove the
clipping blade.
NOTE
►
Make sure the clipping blades are positi-
oned correctly when installing the new or
sharpened blades.
Cattle and Horse Clipper
‹
‹
Abb. 13
‹
1.5 - 2 mm
‹
Abb. 14
NOTE
►
Work only with sharp clipping blades and replace dull blades and blades with mis-
sing teeth. Proper sharpening of clipping blades is only possible by an expert using
specialised equipment. When faced with the need to sharpen the blades, contact your
service centre.

7.9 Lubrication

To achieve a well-clipped animal and to increase
the life of the device including the clipping head, it
is necessary to apply a thin coat of oil between the
upper and lower blades. All other moving parts of
the clipping head must also be lubricated.
‹
Abb. 15
Cattle and Horse Clipper
Place the new upper blade onto the guiding tips
of the swivelling lever.
Apply a few drops of oil on the polished sur-
faces of the upper blade.
Install the new lower blade. Align it so that the
ground surface of the lower blade protrudes ap-
prox. 1.5 - 2 mm above the point of the upper
blade.
Tighten the comb plate screws.
Apply some drops of oil onto the clipping blades
and into the lubrication opening.
39