Operating The Unit - Goodyear GY 33SBC Manual De Instrucciones

Operating manual
R aynaud's dis eas e
(vibration white finger)
The frequent use of vibrating
power tools may damage nerves
in people whose blood circulation
is impaired (e.g. smokers,
diabetics). In par ticular, ngers,
hands, wrists and/or arms may
show some of the following
symptoms:Pain, tingling,
stabbing, numbness of body
parts, skin turning pale.
If you notice unusual
impairments, stop working
immediately and consult a
doctor. You can signi cantly
reduce the ri sks by following
these instructions:
Keep your body, and in particular
your hands, warm in cold
weather. Working with
undercooled hands is the main
contributing factor!
Take regular bre aks and move
your hands. This will stimulate
your blood circulation.
S afety ins tructions for petrol-
driven power tools
Petrol is highly ammable and the
vapours may explode when ignited.
Take the following precautions:
Store petrol only in containers
which are specially designated
and authorised for this purpose.
Ensure that spilled petrol cannot
be ignited. Do not start the
engine until the petrol vapours
have evaporated.
Before refuelling, always switch
o the engine and leave it to cool
down. Never remove the tank
cap or ll the tank while the
engine is hot. Never use the
power tool without screwing on
the tank cap tig ht. Unscrew the
tank cap slowly to reduce
pressure in the tank slowly.
Mix and add petrol in a clean,
well ventilated area outdoors
where there are no sparks or
ames. Unscrew the tank cap
slowly when you have switched
the engine o . Do not smoke
while mixing or topping up petrol.
Immediately wipe spilled petrol
o the power tool.
Move the power tool at least 10
m from the lling station before
starting the engine. Do not
smoke and keep sparks and
naked ames away from the area
while you are topping up the
petrol or using the power tool.
Replace a damaged exhaust,
tank or tank cap.

Operating the unit

Never start t he power tool and
never leave it running if you are
in an enclosed room or building.
The inhalation of exhaust gases
may be fatal. Use the power tool
outdoors only.
Wear eye and ear protection
when using the unit. If working in
a dusty environment, wear a face
or dust mask. A long-sleeved
shirt is recommended. Working
without eye or ear protection may
result in severe e ye injuries or
loss of hearing.
Wear thick, long trousers, boots
(anti-skid) and gloves. Do not
wear loose clothing, jewellery,
short trousers, sandals and do
not walk barefoot. Pin your hair
above your shoulders. If
required, wear a hair net.
The cutting attachment cover
must always be attached when
you use the unit as a lawn
trimmer. Both trim lines must be
pulled out and the correct line
must be installed. The trim line
must not be pulled out over the
end of the cover.
The unit has a clutch. The cutting
attachment stops when the unit is
running at no load. If it does not
stop, have the unit adjusted by a
mechanic at your authorised
dealer.
Before switchin g on the unit,
ensure that the line spool/cutting
blade cannot str ike an object.
Adjust the handle bar to your
height so that the you have the
unit under control.
Operate the unit in daylight or
adequate arti cial lighting only.
Avoid starting t he power tool by
accident. Be ready to operate the
unit when you pull the starter
rope. User and p ower tool must
be in a stable position before the
power tool is started. Follow the
Start/Stop instructions.
Use this unit for its designated
purpose only.
Do not stretch too far over the
unit. Always have a secure
footing and keep your balance.
When operating the unit, always
hold the unit rmly with both
hands. Always hold both sides of
the handle bar rmly.
When operating the unit, always
wear the shoulder belt.
Do not use the unit in adverse
weather conditions, e.g. if there
is a risk of rain or a storm.
Never change the pre-set factory
engine settings.
Work in alternative working
positions and punctually
schedule resting periods to
prevent tiredness and
exhaustion.
Avoid open re, formation of
sparks, and do not smoke.
Never operate the unit with a
defective ignit ion switch.
Keep your hands, face and feet
away from all moving parts. Do
not touch the cut ting attachment
while it is rota ting and do not
attempt to stop it.
Do not take hold of the engine or
silencer. These become very hot
during use. They remain hot for a
short time even when the power
tool has been switched o .
Do not let the engine run quicker
than required for cutting or
trimming of lawn edges. Do not
run the engine at high speed
when it is not cutting.
English
8