Assembling Fan Without The Light Kit - Fanimation Camhaven FP8095 Serie Manual De Instrucciones

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Assembling Fan With the Light Kit (continued)

5. Install included minican bulbs into each of the two

sockets. (Figure 25)

CAUTION

To reduce the risk of fire, use 75-watt max. type

T4-minican JD E11 tungsten halogen bulb. Turn off

the wall switch and allow the bulb to cool for 10

minutes before relamping.

Bulb is pressurized and may shatter. DO NOT

TOUCH BULB WITH BARE HANDS. Fingerprints

may result in shorter bulb life. Remove fingerprints

with alcohol prior to use.

6. Disassemble the finial, trim cover and nut. Then

secure glass bowl to light fitter using supplied nut.

Next, install trim cover followed by the ﬁnial.

Do not over tighten. (Figure 26)

Continue to page 14 if you have assembled your fan with the light kit.

NOTE:

1. Disassemble the adapter/switch cup assembly from

the switch cup support plate by removing three

screws. (Figure 27)

2. Remove one of the three screws in the support

bracket at the bottom of the motor assembly.

Slightly loosen the remaining two screws. Assemble

the switch cup support plate to the support bracket

using the two key slots in the socket plate. Replace

the third screw and securely tighten all three screws

(Figure 28).

3. Remove the hex nut and spring washer from the

adapter/switch cup assembly. (Figrue 29)