How To Assembly The Blades & Light Kit - Fanimation The Jennix FPD7943 Serie Manual Del Propietário

How to Assemble the Blades and Light Kit
1. Position the blade over the motor assembly. Make
sure the blade is fully seated against the flywheel of
motor assembly. Tighten the 1/4-20 x 14 mm screws
to secure the blade to the flywheel of motor assembly.
(Figure 1)
2. Remove one of the three screws in the support
bracket of motor assembly. Slightly loosen the
remaining two screws. Assemble the light plate
assembly to the motor assembly using the two key
slots. Replace the third screw and securely tighten all
three screws. (Figure 2)
3. Connect the 2 single pin connector from the light
socket plate to 2 single pin connector from motor
assembly. (Figure 3)
CAUTION
To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before
installing light kit.
4. Remove one of the three screws in the light plate
assembly. Slightly loosen the remaining two
screws. Assemble the socket plate to the light plate
assembly using the two key slots. Replace the third
screw and securely tighten all three screws.
(Figure 4)
Flywheel
HARDWARE USED:
1/4-20 x 14 mm
SCREWS
MOTOR
ASSEMBLY
MOTOR
ASSEMBLY
Socket Plate
Assembly
10
BLADE
Figure 1
x 6
LIGHT PLATE
ASSEMBLY
Figure 2
SOCKET PLATE
ASSEMBLY
Figure 3
Screws (3)
Light Plate
Assembly
Figure 4