Unpacking Instructions - Fanimation Camhaven FP8095 Serie Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• One ¼" blade screwdriver
▲WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 10).If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in finding your place should you be interrupted.
▲WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 18)
Hanger Bracket
Assembly
Fan Motor
Assembly
• One wire stripper
• Four wire connectors
(supplied)

Unpacking Instructions

Motor Coupling Cover
Ceiling Canopy
Adapter/Switch
Cup Assembly
Glass Bowl
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
Fan Motor Assembly
Adapter/Switch Cup Assembly
Hanger Bracket Assembly
Ball Downrod Assembly
Canopy
Canopy Screw Cover Assembly
Motor Coupling Cover Assembly
Blade Holder Set
Blade Set
Glass Bowl
Light Bulb
Hand Held Remote
Receiver Unit
Canopy Screw Cover
Assembly
Assembly
Light Bulb
Receiver
Hand-Held Remote
Unit
4
Materials
Wire Size A.W.G.
•Hardware bags:
– 3/16˝-24 Washer Head Screw
(blade to blade holder)
– 3/16˝ Fiber Washer
(blade to blade holder)
– 1/8˝-27 Phillips Screw
– 1/4˝-20 Pan Head Screw
(blade arm to motor)
– Phillips Screwdriver, 4˝
– Wire Connectors
– Balance Kit
Ball Downrod
Assembly
Blade Holder Set
Hardware Bag
14
12
Blade Set

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

The camhaven fp8095 serie

Tabla de contenido