How To Assemble The Light Kit - Fanimation The Levon DC FPD7916 Serie Manual Del Usuario

1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws. Assemble
the light plate assembly to the support bracket using
the two key slots in the light plate assembly. Replace
the third screw and securely tighten all three screws.
(Figure 1)
2. Remove one of the three screws in the light plate
assembly. Retain the screw for later. (Figure 2)
3. Connect the 2 pin connector from the motor
assembly to the 2 pin connector from LED assembly.
(Figure 3)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
4. Assemble the LED assembly to the light plate
assembly using the two key slots. Replace the third
screw and securely tighten all three screws. (Figure 4)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
5. Assemble the glass to the LED assembly by twisting
in the clockwise direction. Don't over-tighten. (Figure 5)

How to Assemble the Light Kit

Motor
Assembly
Motor
Assembly
LED Assembly
LED Assembly
Glass
12
Light Plate Assembly
Figure 1
Light Plate Assembly
Figure 2
Figure 3
Light Plate
Assembly
Figure 4
Figure 5
LED
Assembly