Assembling And Mounting The Fan Blades; Installing The Switch Cup Assembly - Fanimation The Edgewood TF971 Serie Manual Del Propietário

Assembling and Mounting the Fan Blades

Assembling and Mounting the Fan Blades
INSTALLATION NOTE
Do not connect fan blades until the fan is
completely installed. Installing the fan with blades
assembled may result in damage to the fan blades.
1. Remove and discard the (rubber) motor "stops" by
removing the five screws. (Figure 13)
2. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade arm.
With a phillips screwdriver, tighten 3/16-24 x 7.5 mm
phillips head screws and flat washers to secure the
blade to the blade arm. (Figure 14)
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
3. Secure the blade holders to the motor support
using the 1/4-20 x 15 mm screws throught the holes
located on the side of the motor support. (Figure 15)
Periodically check blade holder hardware and
NOTE:
resecure if necessary.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
light kit.

Installing the Switch Cup Assembly

1. Securely attach the 9-pin switch cup connector to
wiring harness socket within Switch Cup Assembly.
(Figure 16)
Blade
HARDWARE USED:
3/16-24 x 7.5mm
PHILLIPS HEAD
SCREWS
FLAT WASHER
HARDWARE USED:
1/4-20 x 15mm
SCREWS
9
Figure 13 Figure 13
Blade Holder Arm
Figure 14
x 15
x 15
Figure 15
x 10
Figure 16