Blade Assembly; Light Kit Assembly (Optional). Pgs - Craftmade Sonnet SON52CH Guia De Instalacion

8. Blade Assembly.

Locate 6 blade screws, lock washers and flat
washers in one of the hardware packs. Place
1 lock washer and 1 flat washer (in that order) on
a blade screw. Repeat for each blade screw.
Turn blade so that the WIDE, DEEP holes for the
blade screws are turned toward the floor. Raise
blade to motor, aligning holes in blade with
corresponding holes in motor. Partially insert
2 blade screws (along with the lock washers and
flat washers). Before securing screws
permanently, repeat procedure for remaining
blades. Securely tighten all screws only after all
3 blades have been attached.
Note: Tighten blade screws twice a year.
9. Light Kit Assembly (Optional).
If you wish to use the light kit, remove 1 screw
from motor plate on underside of motor
housing and partially loosen the other 2 screws.
Align slotted holes in center of fitter plate with
loosened screws in motor plate, allowing
female plug from motor housing to come
through hole in middle of fitter plate. Twist
fitter plate to lock. Re-insert screw that was just
removed and securely tighten all 3 screws with
a Phillips screwdriver.
Remove 1 screw from underside of fitter plate
and partially loosen the other 2 screws.
Connect female plug from motor housing to
male plug from LED light kit, matching up the
colors on the male plug with the colors on the
female plug for correct fit. Be sure that plugs
connect securely. [NOTE: If you will NOT be
using the light kit, do NOT connect the plugs.]
["Light Kit Assembly" continued on next
page.]
flat washer
lock washer
blade screw
motor plate
female plug
fitter plate
page 7
motor
housing
blade
motor
housing
fitter
plate
motor
housing
female
plug
male
plug
LED light kit