Resetting Factory Settings; Water Filter; Exchanging The Filter - Thermador T36BT Serie Manual De Uso Y Cuidado

Resetting
factory settings
Recommended after a change
of owner.
Simultaneously hold down
the SETUP and ALARM OFF
buttons for 3 seconds.
If the factory settings are reset:
– an appliance which is switched
off switches on,
– the Super function switches off,
– settings changed in Setup mode
are reset to factory settings.

Water filter

m
WARNING
To avoid serious illness or death,
do not use water that is micro-
biological or chemical unsafe
or of unknow quality without
adequate disinfection or other
treatment before or after use
of filter.

Exchanging the filter

m
WARNING
– After installing a new water filter
always discard the ice produc-
tion of the first 24 hours after
swichting on the icemaker.
– If ice has not been used for
a prolonged time, discard all ice
cubes in the bin and discard
the ice production of the next
24 hours.
– If appliance or ice was not
actively used for several weeks
or months or ice cubes have
an unpleasant taste or odor,
change water filter.
– Air trapped in system may
cause water and cartridge
to eject. Use caution when
removing.
– The filter should be changed
at least every 6 months.
If the following display is indicated:
The age of the filter is close to the
maximum life time. Order a new
water filter.
To purchase a water filter substitute
cartridge contact your local dealer
or call 1–800–578–6890.
If the following display is indicated:
m
– The filter has to be changed
immediately.
m
1. Rotate the filter cap on the base
panel by 90°–180° in an anti-
clockwise direction.
2. Pull the used filter cartridge out
of the appliance.
3. Remove the cap from the used
filter.
Take a new filter cartridge out
of the packaging and remove
the protective cap.
4. Push the cap onto the new filter
cartridge.
21