Single Display Radios - MSA G1 SCBA Manual De Instrucciones

NOTE: After the pairing tag is successfully read, a Bluetooth enabled G1 SCBA will search for a pairing
partner for 8 minutes. If a pair has not been made after 8 minutes, the G1 will stop looking for a pairing
partner. If the 8 minute time out is exceeded, the pairing process should be started over.
NOTE: After a successful pairing, if the regulator is shut off, the G1 SCBA will not remain connected to
the APX radios. As long as the G1 regulator is shut off, the APX radio is available for normal, non-Blue-
tooth use. The G1 SCBA will automatically re-connect to the Motorola radio the next time an end user
breathes on the G1 regulator.
The G1 SCBA and Motorola two display radio are now paired and ready for use.

Single Display Radios

(1) Power on the G1 SCBA.
(2) Power on the Motorola Radio using the volume knob.
Bluetooth
Icon
NOTE: Verify that the Bluetooth icon is visible on the Motorola
display. If the icon is not visible, the radio is either not configured
correctly or Bluetooth is disabled and the radio is not ready for
Bluetooth pairing.
(3) Access the RFID tag reader on the G1 SCBA by pressing and
holding both of the 2 GREEN control module buttons until the
RFID icon displays on the control module.
(4) Place the RFID pairing tag for the radio over the RFID target
on the G1 power module.
(5) Press and hold the side middle (single-dot) button until the
pairing is complete. This pairing process can take up to
30 seconds to complete. The button must remain pressed
throughout the entire process. The radio will give an audible
indication once the pairing is complete.
NOTE: During the long press, the word "VISIBLE" will appear on
the radio display. If the word "VISIBLE" does not appear during the
pairing process the radio was not configured properly.
G1 SCBA
Operation with Bluetooth Radios
US
11