OxyGo FIT Manual Del Usuario página 23

When the concentrator detects that the battery life is low, with less than 10 minutes
remaining, a low priority alert will sound. When the battery is empty, the alert will change
to a high priority.
When battery life is low, do one of the following:
• Plug the OxyGo FIT® into an AC or DC power source using the AC power supply or
DC cable.
• Replace the battery with a charged battery after turning off the OxyGo FIT®
(by pressing the ON/OFF button). To remove battery press and hold the battery latch
button and slide battery off the concentrator.
• If the battery is drained, charge the battery or remove it from the concentrator.
If the OxyGo FIT® is being powered by the AC power supply or DC power, batteries will charge
during operation. Leaving your OxyGo FIT® plugged in past the full charge time will not harm the
concentrator or the battery.
WARNING It is the responsibility of the patient to periodically check the battery and
replace as necessary. Equipment Provider assumes no liability for persons
! C
choosing not to adhere to manufacturers recommendations.
Normal Battery Charging
To ensure that your battery is properly charging, inspect that the correct AC and DC power output
plug adapter is being used and that the adapter is properly inserted into the power outlet.
Observe the display or lights that indicate charging status.
NOTE When starting to charge a fully discharged battery, the charging process may
start and stop during the first few minutes.
Operating Instructions Chapter 3
19