Fastening Of Seatbelt With Safety Cushion Attached - Ece Group 1 (9-18 Kg); Change Over From Group 1 (9-18Kg) To Group 2/3 (15-36 Kg) - CYBEX PALLAS Manual Del Usuario

faStEnInG of SEatbElt WItH SafEty CUSHIon attaCHED - ECE
GRoUp 1 (9-18 KG)
1. Place the child in the car seat.
2. Attach the previously adjusted safety cushion to the child seat (see chapter „Safety
cushion adjustment").
3. Take the lap belt (n) and slide it into the dedicated belt routings (x) (marked red) of
the safety cushion.
Warning! never twist the belt!
4. Insert the belt guide (m) into the belt buckle (l). Listen for an audible „CLICk"
5. Now take the shoulder belt (f) and pull it to tighten lap belt (n).
6. Please slide the shoulder belt (f) parallely to the lap belt into the same belt routing
(x).
7. Pull the belt (f) tight and make sure that the belts (f) and (n) are running completely
inside (over the whole width) of the belt routing (x).

CHanGE ovER fRom GRoUp 1 (9-18KG) to GRoUp 2/3 (15-36 KG)

1. Remove the safety cushion (p).
2. Press the release buttons (q) until you can feel some resistance (d) and pull it
away from the main frame until you feel a resistance.
3. Now pull the reclining handle (v) situated centrally on the bottom of the booster (d)
and completely pull the booster off the frame (w) .
4. for removal of the spacers (s) it is recommended to bring the seat into reclining
position.
5. Pull up the backrest cover (a) to reveal the finger hole on the back side of the
backrest.
6. Push the release button inside the finger hole and pull the spacers (s) out of the
backrest.
7. Repeat this procedure on the other side of the backrest.
note! Please keep all spare parts together and store them properly.
Warning! for reassembly please proceed with these steps in reverse order.
Check the instruction manual in advance to make sure no parts are missing.
15