Substituting The Nozzle In The Oven Burner; Checking Functioning; Maintenance; Spare Parts - Lotus PC-94G Guia Para La Intalación E Instrucciones De Uso

SUBSTITUTING THE NOZZLE IN THE OVEN BURNER

To substitute the oven burner, proceed as follows:
• Remove the oven bottom (floor);
• Unscrew the fixing screws from the burner nozzle protection.
• Substitute the nozzle, using a suitable spanner (see "burners" technical data table on page 7).
•
Regulate the air regulation bush to the corresponding value in the "technical data" table by unscrewing the fixing
screw with relative jam nut, regulate minimum output by turning the screw to the right or to the left until the
thermal power reaches 2,2 kW for the burner of 8,5 kW and 3,5 kW for the burner of 13 kW; this procedure is
only possible after having let the oven burner work at maximum output for about 20 minutes (knob in pos. 300).
• After this procedure, put back the burner nozzle protection.
• Substitute the pilot nozzle, using a suitable spanner.
After regulating, check lighting, at both maximum and minimum output. Make sure that, when changing rapidly
from minimum to maximum output, the flame does not present any problems and that it doesn't go out, when
closing or opening the oven door quickly.
Warning: For functioning with liquid gas, screw down the regulating screw completely.
• The appliance contains the instructions necessary for use.
• Check the appliances for gas leaks.
• Check the lighting and flame of the main burner.
• We urge the user to follow the instructions when using the appliance.
With prolonged use of the appliance, it is essential to carry out regular maintenance for the safe functioning of the
appliance; we therefore recommend drawing up a contract for after sales service.
Maintenance must be done only by specialised personnel, observing the norms in force and our indications.

Open rings:

The cocks can be changed by removing the front panel; to change the thermocouples and burners you have to remove

Gas oven

the gas-cock, timer, thermocouples, burners and ignition plugs can be changed by accessing them inside the oven and/or
by removing the bottom oven panel or control panel.
Attention! The appliance must only be used under surveillance.
GB

CHECKING FUNCTIONING

MAINTENANCE

SPARE PARTS

the rungs and trays.

INSTRUCTIONS FOR USE

IE
IT CH
45