Ice Maker Operation - Amana G32026 Manual De Instrucciones

Installation
To Install:
1. Align drawer handle clips to the left of the studs
attached to the freezer drawer.
2. Ensure the large hole in the mounting clip is
positioned to the right on both ends of the handle.
3. Rotate the handle so the left base is flat against
the door.
4. Grasp the handle firmly and slide handle to the
right.
Handle
Clip
1. With both hands, firmly grasp the handle toward
the right side.
2. Slide toward the left, lift and remove from the
surface.
Handle Removal
Euro Handles
This handle style is installed at the factory
Materials Needed:
• " Allen wrench
3 ⁄
32
To Remove:
• Remove set screw from handle
mounting post using
wrench.
• Repeat the procedure on all posts
to remove the handle.
To Replace:
• Align handle with the mounting posts.
• Fully tighten all set screws to secure handle
in place.
Door
Stud
3 " Allen
⁄
32
Opening and Closing Your
Fresh Food Doors
Your new refrigerator is uniquely
designed with two fresh food doors.
Either door can be opened or closed
independently of one another.
There is a vertically-hinged section
on the left fresh food door. When
the left door is closed, the hinged
section automatically forms a seal
between the two doors when both
doors are closed.
When the left door is opened, the hinged seal
automatically folds inward so that it is out of the way.
WARNING
To avoid electrical shock which can cause severe
personal injury or death, DO NOT attempt to
remove the hinged seal from the fresh food
section.
CAUTION
To avoid possible product damage, ALWAYS verify
that the hinged seal is folded against the edge of
the door prior to closing.
How to Connect the Water
Supply
(select models)
WARNING
Contact a qualified engineer to perform this task.

Ice Maker Operation

• To turn ice maker On push arm down from locked
position.
• Lift arm up and lock into position to turn ice maker
Off.
(select models)
Vertically
Hinged Seal
6