Rear Panel - Pioneer NC-50DAB Manual De Instrucciones

> Before Start > Part Names

Rear Panel

1. AC IN: Connect the supplied power cord.
2. Speaker terminals: Connect speakers with speaker cables.
3. Wireless antenna: Used for Wi-Fi connection or when using a BLUETOOTH enabled
device. Adjust their angles according to the connection status.
4. DIGITAL IN OPTICAL jack: You can play the digital audio from an external device such as
a television connected with a digital optical cable.
5. DIGITAL IN COAXIAL jack: You can play the digital audio from an external device such as
a television connected with a digital coaxial cable.
6. SIGNAL GND terminal: Connect if the turntable connected to the PHONO (MM) IN jack
has a ground wire.
7. DAB/FM ANTENNA jack: Connect the supplied DAB/FM wire antenna.
8. USB port: Connect a USB storage device or HDD (hard disk drive) to play music files. You
can also supply power (maximum 5 V/1 A) to USB devices with a USB cable.
9. NETWORK jack: Connect to the network with an ethernet cable.
10.SUBWOOFER PRE OUT jacks: Connect a subwoofer with built-in amplifier.
4
> Install > Initial Setup
 

> Playback
  
 
11. LINE IN jack: You can play the audio from an external device such as a television
connected with an analogue audio cable.
12.PHONO (MM) IN jacks: Connect a turntable (MM cartridge).
Advanced Setup | Firmware Update | Others
 

90°
180°
 
E
N