Nice Spido Instrucciones Y Advertencias Para El Instalador página 12

Remote memorising
It is possible to memorise a new transmitter in the receiver memory
without using the keypad. A previously memorised and operational
remote control must be available. The new transmitter will "inherit" the
characteristics of the previously memorised one.
Therefore, if the first transmitter is memorised in mode I, the new one
will also be memorised in mode I and any of the buttons of the
transmitter can be pressed. If the first transmitter is memorised in
mode II the new one will also be memorised in mode II but the button
Table "B3" Remote memorising
1. Press the button on the NEW transmitter for at least 5 seconds
2. Press the button on the OLD transmitter 3 times slowly
3. Press the button on the NEW transmitter 1 time slowly and then release
N.B.: If there are other transmitters to memorise, repeat the above steps for each new transmitter
Deleting all transmitters
All the memorised codes can be deleted as follows:
Table "B4" Deleting all transmitters
1. Press the receiver button and hold it down
2. Wait for the Led to light up, then wait for it to switch off and then wait for it to flash 3 times
3. Release the button exactly during the third flash
N.B.: if the procedure was performed correctly, the Led will flash 5 times after a few moments.
12
activating the required output must be pressed on the first transmitter
as must the button required to be memorised on the second.
Read all the instructions and then carry out the operations one after
the other without interruptions. Now, with the two remote controls,
NEW, the one whose code number we want to enter, and OLD, the
previously memorised one, position yourself in the range of action of
the radio controls (within their maximum range) and carry out the steps
shown in the table.
Example
x5s
TX TX
1s 1s 1s
TX TX TX
x1
TX
Example
RX
x3
RX 3°
x5