Troubleshooting - Worx VERSACUT WX420L Manual De Instrucciones

TROUBLESHOOTING

Symptom
Tool will not start when operating
the on/off switch.
Cutting depth is less than that is
set.
Blade spins or slips
Blade will not cut a straight line.
Blade kicks back when beginning
a cut
Mini Circular Saw
Possible Causes
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn down
Sawdust accumulated at the
rear of the base.
Blade is not tightly engaged
with the spindle.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided
properly.
Blade is not spinning fast
enough
Possible Solution
Check to make sure power cord is
connected well into a working outlet.
Unplug the power cord. Replace it
using a qualified maintenance person.
Replace the carbon brush using a
qualified maintenance person.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Remove the blade, and reassembled
it as described in Mounting and
Removing the Blade section.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use an edge guide.
Allow the saw blade to reach full
speed prior to beginning a cut
17
EN