Wiring - Ditel SYROS SY24 Manual De Instrucciones

2 Wiring

Terminal connection diagram (100 to 240 VAC) or (24 VDC/24 VAC)
SY24
Salida control 2
Salida SSR/SSC
Relé
Salida alarma 2
Entrada de valor medido
Corriente/Voltaje Sensor
Note1) Check the power supply voltage before installation.
Note2) Connect the 250 Ω resistor) (accessory) between the terminal w and e in case of current input.
Note3) Tighten the terminal screw securely with fastening torque of 0.4N·m.
Note4) When the 10th digit of the code symbol is "C", "A", or "B", connect the power according to the connection diagram of
24VAC/24VDC power supply. Input of power of 30VAC/30VDC or more will damage the instrument.
Designation of Wiring Material
4-20 mADC
Termopar
Salida control 1
Salida SSR/SSC
Relé
Entrada digital 1
Salida alarma 1
4-20 mADC
CAUTION:
short circuit, never use the wire other than
the one stated above, and make sure to
insert it toward the recess of the terminal
block. Fastening torque: 0.4N·m
12
Communication
Entrada digital 2
Alimentación
To prevent disconnection or
Retransmission
Nota 4