Guided Tour - Vt3L Beltpack Transmitter - Samson VHF Micro El Manual Del Propietario

Guided Tour - VT3L
1 2 3
LOW MID HIGH
BATTERY
AUDIO ON
SAMSON
1: Input connector - The input device is connected here. The VT3L is supplied with
either a lavalier or headset microphone (connected via a Switchcraft mini-XLR jack).
A wiring chart showing the connections to popular lavalier and headset microphones can
be found on page 41 of this manual.
2: Battery level meter - This set of three multicolor LEDs indicates relative battery
power, indicating whether the installed battery is at low (red), mid (yellow) or high (green)
strength. One or more of these will light whenever the VT3L is powered on (see #5 on the
next page). When all three are lit, the battery is at maximum strength. When only the red
"low" indicator lights, RF performance is degraded and the battery needs to be replaced.
3: Audio on-off switch - When set to the "on" position, audio signal is transmitted.
When set to the "off" position, the audio signal is muted. Because the carrier signal
remains during muting, no "pop" or "thud" will be heard. Note that turning this off does not
turn off the transmitter power—it is simply a way to temporarily mute the transmission of
audio signal. If you don't plan on using the transmitter for extended periods, turn off the
transmitter power by using the power on-off switch (see #5 on the next page).
4: Battery door release - Press gently inwards on these two indents in order to open the
battery door of the VT3L and access the Power on-off switch (see #5 on the next page)
and Gain control (see #6 on the next page).
INPUT
VT3L
SAMSON
4
4
VHF BELTPACK TRANSMITTER
7