Idiomas disponibles
Idiomas disponibles
3) Wire harness
Bind the throttle cable and the flexible shaft with two
bands.
(3) Adjustment of throttle cable
• Throttle cable should be paralleled to flexible
shaft. In case of twisting, they should be restored
by parallel.
• Throttle cable should be adjusted under the
bended flexible shaft as shown.
1) Adjust the cable adjuster sleeve so the stop on the
carburetor throttle cam just contacts the throttle stop
and the cable position keep 1-2mm play between
cable lug and slotted fittings when the throttle trigger
is fully depressed.
2) When the throttle cable is adjusted correctly, tighten
the lock-nut.
(4) Loop handle
1) Place the rubber sleeve around the shaft.
2) Place the loop handle and the bracket over the
rubber sleeve.
3) Install the four screws with stay and nuts as shown.
Tighten the screws evenly.
(5)Blade Guard
Attach the blade guard to the gearcase with the two M6×30
screws as shown on Fig. 1.
(6) Guard Extension
1) Insert the square nut into guard extension as
shown on Fig. 2.
Flexible Shaft
Throttle cable
Throttle Cable
Screws (4)
Rubber sleeve
Bracket
Nuts (4)
― US-3 ―
Band
1-2mm Play
Flexible Shaft
Loop Handle
Stay
M6×30 Screw(2)
Gearcase
Blade Guard
Fig.1
Square nut
Guard extension
Fig.2
