Wiring Instructions; Removing The Front Cover - YASKAWA V1000 Serie Guía De Referencia Rápida

Wiring Instructions

WARNING! Never remove the front cover while the power is on. Failing to do so may result in serious electric shock.

Removing the Front Cover

Accessing the main circuit and control circuit wiring requires the front cover of the drive to be removed. Drives with model code
(with built-in digital operator) the connecting cable for the digital operator has to be plugged out at the operator before the front cover can be
removed.
NOTICE: Never disassemble the protective case that encloses the drive. The case is constructed as a single continuous piece that includes the heatsink. Attempting to
disassemble the case can therefore damage the drive.
1.
Loosen the screws that hold the front cover in place, and remove the front cover.
2.
For disconnecting the operator cable, firmly press the tab that is holding the cable in place and then pull out the plug as shown in the figure
below. Disconnect the cable only from the operator at the front cover (cable is fixed to the drive side on size B units)
Main Circuit and Control Circuit Wiring
Note: Before wiring up the drive, remove the sealing grommets from the access holes in the bottom of the drive. The figure below explains the purpose of each hole. Make
sure the proper holes are used. Do not remove the rubber bushings from holes that will not be used.
NOTICE: Be sure to use the recommended waterproof cable glands for all cables entering and exiting the drive.
NOTICE: RJ45 connector on drives with model code CIMR....-0081 is meant to connect an external digital operator JVOP-180(LCD), JVOP-182(LED) (with recommended
cable, YASKAWA part No. 72606-WV003) or JVOP-181 (USB Copy Unit) for PC connection. Do NOT connect any other device to the RJ45 connector. Otherwise
the drive or external device may be damaged.
1.
After removing the rubber bushings, insert the cable glands into the holes and tighten them with the locknut.
Refer to Cable Glands Specifications and Model Numbers on page 10
YASKAWA Europe TOMP_C710606_75A V1000 IP66 - Quick Start Guide
Power Supply Cable
optional RS485 connector
(CIMR.... -0081 variant)
Cable Gland
(Body)
Front Cover
Remove cable
Connector Release Tab
Control circuit and
option wiring
Motor Cable
External earthing connector
for the maximum allowable tightening torque.
Cable Gland
(Locknut)
2 Mechanical Installation
-0080
CIMR...
EN 9