Description Of The Commands - Gewiss Chorus GW 10 795 Manual De Instalación

COMMAND PUSH-BUTTONS
1
Select operating mode / Confirm
2
Adjust temperature (+) / Visualise pages
3 Adjust temperature (-) / Visualise pages
Setting the parameters
4
INFORMATION ON THE DISPLAY
5
Clock / KNX temperature adjustment probe visualised
6
Settings menu / Set the values to send to the KNX temperature adjustment probe
7 Heating activation 1° stage (flame) or 2° stage (flame+asterisk)
Air-conditioning activation 1° stage (snowflake) or 2° stage (snowflake+asterisk)
8
9 Type of operation: heating
10 Type of operation: air-conditioning
11
Enable remote commands
Fan coil operating mode
12
- speed OFF
- speed 1 (automatic / manual)
- speed 2 (automatic / manual)
- speed 3 (automatic / manual)
13 Thermostat in Slave operation
Measured temperature / Temperature measured by KNX temperature adjust-
14
ment probe / Setpoint on KNX temperature adjustment probe input
15 Temperature measurement unit
Indication of auxiliary input status (I = contact closed, O = contact open)
16
Thermal residual current device
17
18 Visualisation of temperature measured by KNX temperature adjustment probe
19 Thermostat mode
- Economy (in heating mode) - Comfort (in air-conditioning mode)
- Pre-comfort (in heating mode and air-conditioning mode)
- Comfort (in heating mode) - Economy (in air-conditioning mode)
- Anti-freeze / High temperature protection
GENERAL DESCRIPTION

Description of the commands

18
Symbol