Gewiss Chorus GW 10 795 Manual De Instalación página 16

The device is configured with the ETS software, to perform the following functions:
Temperature control
• at 2 points, with ON/OFF commands or 0%/100% commands
• integral proportional control with PWM commands or continuous adjustment (0% -
100%)
Fan coil management
• control of fan coil speed, with ON/OFF selection commands or continuous adjustment
(0% - 100%)
• management of 2-or 4 way systems, with ON/OFF commands or 0%/100% commands.
Operating mode setting
• from the BUS, with distinct 1-bit objects (OFF, ECONOMY, PRE-COMFORT, COMFORT)
• from the BUS, with a 1-byte object.
Operating Setpoint setting
• from the BUS, with a 2-byte object.
Temperature measurement
• with a built-in sensor
• mixed built-in sensor / KNX temperature adjustment probe / external temperature
sensor with definition of the relative weight.
Underfloor probe
• setting of threshold value for floor temperature alarm.
Temperature control for specific zones
In "Slave" control mode:
• with the operating mode received by the Master device, and the use of a local Setpoint
• with the Setpoint value received by the Master device, and local residual current device
for temperature.
In "autonomous" control mode:
• with local selection of operating mode and Setpoints
• with local selection of operating Setpoint.
Scenes
• storage and activation of 8 scenes (value 0..63).
Other functions
• setting of the Setpoint (OFF, ECONOMY, PRE-COMFORT, COMFORT) from the BUS
• setting of the operating Setpoint from the BUS
• setting of the type of operation (heating / air-conditioning) from the BUS
• transmission of the status information (mode, type), measured temperature and current
Setpoint on the BUS
• management of the status information arriving from the commanded actuator
• management of the status signalling window for temporarily switching off the
thermostat
• auxiliary input for fronts management, brief/prolonged operation, dimmer with single
push-button, roller shutters with single push-button, scenes and window contact
• auxiliary output for controlling the thermostat solenoid valve for heating/air conditioning,
or used as a general output for executing On/Off commands, timed commands, priority
commands and scene management
• management of display parameters.
GENERAL DESCRIPTION GENERAL DESCRIPTION
16