Installation Menu (Pwd 0030) - AERMEC ANKI 020 Manual De Instrucciones

N Code
U11 tC1
U12 SC2
U13 tC2
U14 SAS
U15 bAS

INSTALLATION MENU (PWD 0030)

N Code
N00 Reg
N01 oFF
N02 oFC
N03 SAF
N04 int
N05 AG
Name Min Default Max
Outside heating
air temperature -40.0 0
1 (°C)
Heating
15.0 35.0
setpoint 2 (°C)
Outside heating
air temperature -40.0 18.0
2 (°C)
Domestic water
25.0 50.0
setpoint (°C)
Domestic water
1.0 10.0
band (°C)
Name Min Default Max
Input output 0 0
Cooling force
-25.0 4.0
off (°C)
Heating force
30.0 58.0
off (°C)
Force off resetting
0.5 5.0
band. (°C)
Integral (sec) 0 600
Anti-freeze (°C) -50.0 3.0
Meaning
Visible only with the setpoint correction enabled. Outside air temperature
50.0
corresponds to set at hot 1 (parameter A).
Visible only with the setpoint correction enabled. Set to hot 2. Set to hot
used as second extreme between which the set can be changed.
*The maximum limit can be configured using the parameter(t) in the menu
Parameter N30 with PSW=30.
The maximum limit becomes 70° if the parameter(8) =4 to allow setpoint
entry to adjust the boiler.
Visible only with the setpoint correction enabled. Outside air temperature
50.0
corresponds to set at hot 2 (parameter C).
Setpoint temperature used when the production of domestic water is
enabled.
*The maximum limit can be configured using the parameter(t) in the menu
Parameter N30
with PSW=30.
The maximum limit becomes 70° if the parameter(8) =4 to allow setpoint
entry to adjust the boiler.
20.0 Temperature band used with the domestic water mode setpoint.
Meaning
If 0 - the machine makes adjustments in relation to the output tempera-
ture. If 1 - it makes adjustments in relation to the input temperature. If 2
- the machine makes adjustments in relation to the temperature of the re-
mote probe ready by the DHW control panel (if the remote probe is faulty,
2
the machine resumes adjustments through the input probe and sends
the alarm code 157 signal). if domestic hot water production is activated,
the adjustment is automatically forced on the water output temperature
regardless of the value of this parameter.
Force off limit for operating the machine at cold (on reaching this limit, the
wager leaving the compressor is switched off but no alarms are signalled).
25.0 This threshold is only enabled is the low water content algorithm is used
(dip 6 set to OFF). It is always enabled on the water output even if the
input adjustment is selected.
Force off limit for operating the machine at hot (on reaching this limit, the
compressor is switched off but no alarms are signalled). This threshold is
70.0 only enabled is the low water content algorithm is used (dip 6 set to OFF).
It is always enabled on the water output even if the input adjustment is
selected.
Over the value of parameter (1) added to this parameter, the compressor
20.0
resets.
Integral parameter. It shows the time interval in which a proportional error
999
equivalent to 1°C is such to cause the thermostat to be activated.
20.0 Anti-freeze alarm threshold.
9