Troubleshooting - Fagor PBZ3VE202FTN Manual De Instrucciones

TROUBLESHOOTING

In the event of any fault:
● turn off the appliance
● disconnect the power supply
● have the appliance repaired
● Based on the instructions given in the table below, some minor issues can be corrected
by the user. Please check the consecutive points in the table before you refer the repair to
customer service.
PROBLEM
1.The appliance does not
work
2.Sensor fields do not re-
spond when touched
3.The appliance does not
respond and emits and
extended beep
4.The appliance switches
itself off
5.A single cooking zone swit-
ches off and residual heat
indicator „H" is shown.
POSSIBLE CAUSE
- no power
- appliance is not turned on
- sensor field touched
too briefly (less than one
second)
- multiple sensors touched
at the same time
- improper use (wrong
sensor fields touched or
sensors touched too briefly)
- sensor fields covered or
dirty
- no sensor field is touched
for 10 seconds of activating
the appliance
- sensor fields covered or
dirty
- limited cook time
- sensor fields covered or
dirty
- electronic components over-
heated
REMEDY
-check the fuse, replace if
blown
- turn on the appliance
- touch the sensor field
longer
- always touch only one
sensor field (except when
a cooking zone is switched
off)
- reconnect the hob
- uncover or clean the sen-
sor fields
- switch on the appliance
and set heat setting without
delay
- uncover or clean the sen-
sor fields
- switch on the cooking zone
again
- uncover or clean the sensor
fields
45