Fulgor Milano FPRHD 362 TC X Manual De Instrucciones De Uso Y De Montaje página 15

USES
The appliance has been designed to work
both in filtering and sucking mode.
* In the filtering version (fig. 1), the air and fu-
mes conveyed by the appliance are purified by
both a grease filter and an activated charcoal fil-
ter, and then re-circulated into the room through
the side-grids of the chimney.
When the appliance works in this mode, we re-
commend the use of an air deflector (Fig. 1A) to
be placed on the upper part of the pipe, allowing
the air to be re-circulated into the room.
* In the sucking version (fig. 2), fumes are di-
rectly conveyed outside the building, through the
top or rear air out-let. The use of a charcoal filter
and air deflector is not necessary in this case.
INSTALLATION
*Before installing the appliance, make sure that
none of the parts is damaged in any way.
In case of damaged parts, contact your retailer
and do not proceed with installation.
Read all of the following instructions carefully be-
fore installing the appliance:
- Use an air outlet pipe of the shortest possible
length.
- Limit the number of pipe elbows.
- Use a material approved by standards and
regulations.
- Avoid any sudden changes in the pipe section
(recommended constant diameter: Ø 200 mm or
equal surface area).
-The manufacturer shall not respond for air ca-
pacity or noise problems due to non- compliance
with above mentioned instructions, and no war-
ranty shall be given.
The appliance air outlet is directed upwards:
if you prefer to have the air outelt directed to-
wards the rear side of the appliance, you will
need to replace the air outlet upper fittig with the
rear one supplied with the appliance (Fig. 3).
Remove the grease filter before installation, in
order to prevent the appliance from being dama-
ged.
To remove the metal grease filter, push the speci-
fic filter handle towards the hood rear side, rota-
ting the filter downwards (Fig.4)
Drill the holels to fix the wall bracket, using the
related template (drawings 5, 6); Appliances shall
be installed at 650 mm from the hob surface.
Fasten the brackets to the wall using the dowels
and screws supplied with the appliance.
Hang the suction body (drawing 7) to the wall bra-
ckets previously fixed.
Fit the four fixing screws into the holes found on
the appliance top side. (fig. 8). Tighten the front
screw to secure the appliance to the wall, then
check that the hood is perfectly flush; if not, act
on the rear screws and tighten either the right
screw to lift the appliance right side, or the left
one to raise the hood left side.
15