Installing A Main Monitor In A Second Residence; Switching The Installation On - SOMFY V300 Manual De Instalación

V300

5.2 Installing a main monitor in a second residence

The V300 can be adapted to a two-residence format with a multi-button station. However, this type of installation requires the
addition of a junction box (not supplied in the kit) to be placed between the door station and the monitors in each (see diagram
below).
The monitors are installed as per the standard installation (see section "4.1 Installation for one residence" of the instructions for
the V300 kit) with a maximum distance of 100 m between the door station and the monitor furthest away. When wiring, the mains
adaptors of residence 1 and residence 2 must be disconnected from the mains. For each residence, the polarities must be respected
(see section "5.1 Wiring the door station" of the instructions for the V300 kit):
- M+ of the monitor to M+ of the door station.
- M- of the monitor to M- of the door station.
Before installing the monitors, the switch (18) at the rear of the monitors must be configured to distinguish between the two
residences and thus be able to use the two call buttons on the door station:
6-1
6-2
6-1
Call button for residence 1
6-1
6-2
6-2
Call button for residence 2

5.3 Switching the installation on

Once installation is complete, reconnect the mains adaptors of the monitors.
The installation is ready to use.
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.
Residence 1
18
Residence 2
18
EN EN
2 1
2 1
7