Height Of Cut Adjustment; Verticut Reel Adjustment - Ransomes LH Serie Manual De Seguridad, Funcionamiento Y Mantenimiento

9.1

HEIGHT OF CUT ADJUSTMENT _______________________________________

The height of cut can be set from 12mm (15/32 in) to 85mm
(3 11/32 in).
There are two methods of adjustment.
Method 1. For quick adjustment.
Three settings at 62mm (2 7/16 in), 73mm
(2 29/32in), 85mm (3 11/32in) maximum intervals are
provided in the mounting bracket (A).
To adjust:
(a) Slacken the nut and bolt (B) until the locating collars (C) are free.
(b) Move the cutting unit up or down to the required setting and tighten the nut and bolt securely.
Method 2. For finer adjustment.
When the mounting brackets are positioned in the lower
setting the height of cut can be adjusted from 12mm (15/
32in) up to 63mm (2 31/64in) by means of the rear roll
adjusters. To adjust:
(a) Slacken the screws (B) which clamp the skids to the
side frames.
(b) Turn the adjusters (A) clockwise to reduce the height
of cut, and anticlockwise to increase the height of
cut.
(c) Tighten the screws securely. Adjust both sides equally.

VERTICUT REEL ADJUSTMENT

The position of the reel must nit be altered after being set. Any changes required in height must only be made by
moving the front and rear rolls. Normal settings of the blades is that the tips should be 3mm (1/8in) above the
ground. The blade tips MUST NOT penetrate the top surface of the soil.
To adjust:
1. Release bolt and nut (A) at front end.
2. Turn adjusters (B) above rear roll clockwise to
reduce height of cut and anticlockwise to increase
height of cut.
3.
re-tighten nut (A) at front of skid.
9 ADJUSTMENTS
B
A
en-33