During Overhaul - Ransomes LH Serie Manual De Seguridad, Funcionamiento Y Mantenimiento

4. Using general purpose grease, lubricate the valve
lever pivot bolt (A) and the connecting link (B).
5. Check oil level through sight gauge (C) and If
necessary, top up with the appropriate oil. Ensure
tractor is on a level surface.
IMPORTANT: Do not lubricate the rear unit trailing arm
spherical bearing.
First 50 working hours
Change P.T.O. gearbox oil.
1. Remove Filler/breather plug (B), sight gauge (C)
and drain plug (A) and drain oil into an appropiate
container.
Contact With Oil Can Damage Your Skin. Use
Gloves When Working With any Oil. If You
Come In Contact With Oil, Wash It Off
Immediately.
Dispose Of Used Oil In Accordance With Local
Regulations
2. Clean sight gauge and drain plug before replacing them. Refil gearbox with appropiate oil to the correct
level. Clean and replace filler/breather.

8.3 DURING OVERHAUL __________________________________________________

When rebuilding a cutting unit after it has been dismantled for overhaul:
1. Clean the cutting unit gearboxes and repack approximately ½ full with Shell Alvania HDX2 grease.
2. Lubricate cutting cylinder adjusting screws and clamp pivots with Molybdenum Disulphide grease.
CAUTION
CAUTION
8 MAINTENANCE & LUBRICATION
B
A
C
en-31