Removing The Led Control Panel Assembly - Dell EMC PowerEdge R230 El Manual Del Propietario

5 tabs on the LCD control panel (6)
Figure 78. Installing the LCD control panel board—four hard drive chassis
1 screw (2)
3 display module cable
5 USB connector cable
Next step
Follow the procedure listed in the After working inside your system section.

Removing the LED control panel assembly

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Disconnect the cables connected to the control panel module.
CAUTION: Do not use excessive force when removing the control panel as it can damage the connectors.
Steps
1 For cabled hard drive chassis, perform the following steps:
a Remove the screw(s) that secure the LED panel to the chassis.
b Remove the LED panel.
2 Remove the screws that secure the control panel board to the chassis.
3 Lift the control panel board away from the chassis.
128 Instalación y extracción de los componentes del sistema
2 control panel connector cable
4 LCD control panel board
6 standoff on the chassis (2)