Install Refrigerator And Overlay Panels - JENN-AIR JS42NXFXDW Manual De Instalación

3. Continue adjusting all of the leveling legs to raise the
refrigerator until the top is within at least ¹⁄₄" (6.35 mm) of the
top soffit.
NOTE: If an anti-tip board has been used, adjust the leveling
legs until the top of the refrigerator is within ¹⁄₄" (6.35 mm) of
the bottom of the anti-tip board as shown. Do not crush the
compressor cover.
A
2" (5 cm)
D
¹⁄₄
A. Center board " (6.35 mm) max. above refrigerator
B. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards
C. Attach to studs with six #8 x 3" (7.6 cm) screws
D. Compressor cover
E. Distance from bottom of anti-tip board to floor
IMPORTANT: Adjust in small increments to keep from
damaging the cabinet trim and causing problems with the
door alignment or top grille fit. To avoid damage to the cabinet
or leveling legs, do not apply more than 50 inch-pounds
(5.65 Nm) of torque to the leveling bolts. The leveling legs can
be extended to a maximum of 1¹⁄₄" (3.18 cm) below the rollers.
4. After leveling the refrigerator, again use a straight edge or
4 foot level across the front of the refrigerator installation
blocks to the cabinets to check that the refrigerator is still
flush.

Install Refrigerator and Overlay Panels

IMPORTANT: Jenn-Air is not responsible for the removal or
addition of molding or overlay panels that would not allow access
to the refrigerator for service.
Install Refrigerator to Adjacent Cabinets
1. Open the refrigerator and freezer doors to locate the cabinet
brackets on each side.
2. Using the bracket holes as a template, predrill a ¹⁄₈" deep pilot
hole into the adjacent cabinet.
B
C
¹⁄₄
" (6 mm)
max.
84"
(213.4 cm)
E
3. Using two round head screws (provided) for each bracket,
anchor the refrigerator to the adjacent cabinets.
4. Repeat steps 2 and 3 to anchor the other side of the
refrigerator to the adjacent cabinets.
Install Cabinet Side Trims
Install cabinet side trims to hide the brackets fastening the
refrigerator to the adjacent cabinets.
1. Open both doors to a 90° angle.
2. With the lip edge of the trim toward the back wall, insert the
cabinet side trim between the side of the refrigerator and the
adjacent cabinetry.
NOTE: Keep the top edge of the trim piece flush with the top
of the refrigerator. Installing the trim higher than the
refrigerator top could cause damage to the trim when the door
is opened.
3. Slide the trim toward the back until it snaps into place.
A
A. Cabinet side trim
B. Freezer door
B
15