Tabla de contenido
Idiomas disponibles
Idiomas disponibles
I
NSTALLATION
H
R
OW TO
EPLACE THE
D
H
OOR AND
INGES
1. Install center hinge with Phillips
screws.
2. Install stabilizing brackets with
head screws.
3. Replace
center
hinge pin.
4. Place hinge side of
refrigerator door on center hinge pin.
Note:
If fresh food door is being reversed,
install alternate top hinge from
literature assembly.
5. While
holding
refrigerator door
upright,
tighten
down top hinge
5
with
" hex head
⁄
16
driver.
6. Install top door trim of fresh food
door with a Phillips screwdriver.
I
NSTRUCTIONS
H
OW TO
R
EMOVE
(SOME MODELS)
WARNING:
3
" hex
⁄
8
To avoid personal injury or property
damage, fresh food panel should not
weigh more than 30 lbs (14 kgs) and
freezer panel should not weigh more
than 15 lbs (7 kgs).
TO INSTALL PANELS:
1. Perform
the
instructions in How to Install and
Remove the Handles, including
instructions to remove mounting
posts from door face.
2. Remove top door trim.
3. Remove handle side door trim.
4. Slide panel in the handle side of door,
by using grooves provided by bottom
door cap and side door trim.
5. Replace mounting posts, handles, and
trim.
TO REMOVE PANELS:
1. Perform
the
instructions in How to Install and
Remove the Handles, including
instructions to remove mounting
posts from door face.
2. Remove top door trim.
3. Remove handle side door trim.
4. Slide panel out the handle side of
door.
,
.
CONT
I
NSTALL AND
P
ANELS
handle
removal
handle
removal
6
W
I
HAT IF
AM
I
R
NSTALLING
AISED
P
?
ANELS
Please see recommended dimensions for
paneling. All panel holes are
FP
FP
FP
FP
FP
FP
FP
FP
H
D
I M
OW
O
OUNT
H
O
R
ANDLES
N
P
?
ANELS
The refrigerator is shipped with the
handle mounting posts attached to the
door with
1
" hex head screw that is
⁄
4
approximately 1
1
" long. This length is
⁄
2
necessary to safely secure the mounting
post to the door.
If handles are being mounted to a raised
surface, the factory supplied hex head
screws will have to be replaced with a
longer version. To determine how long
the replacement screw must be, add the
thickness of the raised panel to the 1
measurement. See example below.
1
1
" long
1
" hex
⁄
⁄
2
4
1" thick raised
head screw (factory
panel = 2
installed)
1
⁄
1
" diameter.
⁄
4
FP
FP
AISED
1
"
⁄
2
1
⁄
" long
2
" hex head screw
4
Capítulos
Tabla de contenido
