PRECAUTIONS
I Do not attempt to disassemble the camera.
To prevent electric shock, do not remove screws or
covers.
There are no user-serviceable parts inside.
Ask qualified service personnel for servicing.
I Handle the camera with care.
Do not misuse the camera. Avoid striking, shaking, etc.
The camera could be damaged by improper handling
or storage.
I Do not expose the camera to rain or moisture, nor
try to operate it in wet areas.
This product is designed for indoor use or locations
where it is protected from rain and moisture.
Turn the power off immediately and ask qualified serv-
ice personnel for servicing.
Moisture can damage the camera and also create the
danger of electric shock.
I Do not use strong or abrasive detergents when
cleaning the camera body.
Use a dry cloth to clean the camera when it is dirty.
When the dirt is hard to remove, use a mild detergent
and wipe gently. Care should be taken not to scratch
the dome cover when wiping it.
Afterwards, wipe off the remaining detergent with a dry
cloth.
I Never aim the camera at the sun.
Whether or not the camera is in use , never aim it at the
sun or other extremely bright objects. Otherwise,
blooming or smear may be caused.
I Do not point the camera at a strong light source.
Intense light such as that produced by a spotlight con-
centrated on one part of the screen can cause bloom-
ing (rainbow around the strong light) or smearing (verti-
cal stripes above and below the strong light).
I Do not install this camera upside down.
This camera is designed for mounting on the ceiling or
wall. Using this camera installed upside down, for
example, mounted on the floor, may cause malfunction.
Bright Subject
Blooming
Smearing
I Do not operate the camera beyond the specified
temperature, humidity or power source ratings.
Do not use the camera in an extreme environment
where high temperature or high humidity exists. Do not
place the camera near heat sources such as radiators,
stoves or other units that produce heat.
Use the camera under conditions where temperature is
between –10 °C - +50 °C {14 °F - 122 °F}, preferably
+40 °C {104 °F}, and humidity is below 90 %.
The input power source is 220 V - 240 V AC for WV-
CS570 and 24 V AC for WV-CS574E.
I Do not install the camera near the air outlet of an
air conditioner.
The lens may become cloudy due to condensation if
the camera is used under the following conditions.
• Rapid temperature fluctuations by switching the air
conditioner on and off.
• Rapid temperature fluctuations due to frequent door
opening and closing.
• Use in an environment where eyeglasses become
foggy.
• Use in a room filled with cigarette smoke or dust.
If the lens becomes cloudy due to condensation,
remove the dome cover and wipe all moist surfaces
with a soft cloth.
• Avoid use of this camera in a food preparation area
and other locations where there are large amounts
of steam vapor and oil.
I Consumables
Parts having contacts such as the lens-drive motors,
cooling fan motor and slip-rings inside the camera are
subject to wear with time. Please ask the nearest serv-
ice centre about replacement and maintenance of such
parts.
I Do not aim the camera at the same object for a
long time.
Burn-in of an image may be caused on the fluorescent
screen of CRT.
I Self-diagnosis Function
If the camera continues operating abnormally for 30
seconds or more due to such an accident as external
noise, the camera will automatically reset its power. In
the case it happens frequently, check if there would be
any environmental cause.
-6-