Precautions - Panasonic WV-CW384E Manual Del Usuario

Precautions

This product has no power switch.
Power is supplied from an external 12 V DC/24 V AC (WV-
CW384) or 220 V to 240 V AC (WV-CW380) power-supply
device. Refer to service personnel for how to turn on/off the
power.
To keep on using with stable performance
• Parts of this product may deteriorate and it may shorten
lifetime of the product when using in locations subject
to high temperatures and high humidity.
Do not expose the product to direct heat such from a
heater.
• Use this product at temperature within –30 °C to
+50 °C* and humidity below 90 %.
* –10 °C to +50 °C at 12 V DC
Do not drop metallic parts through slots.
This could permanently damage this product. Turn the
power off immediately and contact qualified service per-
sonnel for service.
Do not rub the edges of metal parts with your hand.
Failure to observe this may cause injury.
Do not attempt to disassemble this product.
To prevent electric shock, do not remove screws or covers.
There are no user-serviceable parts inside.
Ask qualified service personnel for servicing.
Handle this product with care.
Do not abuse this product. Avoid striking, shaking, etc.
The product could be damaged by improper handling or
storage.
Cleaning this product body
Turn the power off when cleaning the product. Use a dry
cloth to clean the product. Do not use strong abrasive
detergent when cleaning the product body. When the dirt is
hard to remove, use a mild detergent and wipe gently.
Then, wipe off the remaining detergent with a dry cloth.
Otherwise, it may cause discoloration. When using a chemi-
cal cloth for cleaning, read the caution provided with the
chemical cloth product.
Clean the lens with care.
Do not clean the lens with strong or abrasive detergents.
Use lens tissue or a cotton tipped applicator and ethanol.
Discoloration on the CCD color filter
When continuously shooting a bright light source such as a
spotlight, the color filter of the CCD may have deteriorated
and it may cause discoloration.
Even when changing the fixed shooting direction after con-
tinuously shooting a spotlight for a certain period, the dis-
coloration may remain.
Do not aim this product at strong light sources.
A light source such as a spot light causes a blooming (light
bleeding) or a smear (vertical lines).
Smear
Blooming
About the dehumidifying device
• This product has dehumidifying device to keep the
inside at low moisture level, preventing condensation
and quickly dissipating dew if produced.
• Dew may be produced depending on the conditions of
temperature, humidity, winds, and rain, and it may take
time to dehumidify.
• Never seal the surfaces of the dehumidifying device.
Dehumidifying device
Turn the circuit breaker off which supplies this product
with the power when abnormal conditions are encoun-
tered.
Do not operate this product beyond the specified tem-
perature, humidity or power source ratings.
Use this product at temperature within –30 °C to +50 °C*
and humidity below 90 %. The input power source is 12 V
DC/24 V AC (WV-CW384) or 220 V to 240 V AC (WV-
CW380).
* –10 °C to +50 °C at 12 V DC
Use at low temperatures
• To operate the camera at temperatures of –10 °C or
lower, it will take 30 minutes or more after turning on the
power to warm up the camera.
• Images may be disturbed because the built-in heater is
automatically toggled between ON and OFF resulting
from a change in usage environment.
What to do if OVER HEAT appears on the display.
This message indicates that the inside of this product has
become extremely hot. Immediately turn off the product
and contact your dealer.
Bright subject
7