Synchronising Transmitter / Receiver - Silvercrest Z31370A Instrucciones De Utilización Y De Seguridad

Preparing for use / Operation
Receiver:
Remove the battery compartment cover
device.
Remove the used batteries, if present.
Insert 2 batteries (1.5 V
note: Ensure correct polarity. This is indicated in the battery
compartment
Close the battery compartment
Transmitter:
Remove the holder
Remove the used batteries, if present.
Insert a battery (3 V
face upwards.
Fasten the holder
Operation

Synchronising transmitter / receiver

Synchronise the transmitter and receiver as follows:
As soon as the batteries are installed, the receiver enters synchronis-
ing mode.
You can also manually enter synchronising mode by holding the
synchronising button
The signal indicator
Press the chime button
will illuminate once.
54 GB/MT
, type AA).
.
10
from the back of the transmitter.
15
, type CR 2032). The side marked "+" must
of the receiver back on to the back of the device.
15
for approx. 3 seconds.
2
on the receiver will light on.
1
, the signal indicator
13
from the back of the
9
.
10
11
on the transmitter