Maintenance; Filling The Water Tank - Dimplex CDFI1000-PRO Manual Del Propietário

Maintenance

WARNING: Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of fire, electric
shock or damage to persons.

Filling the water tank

When the water tank is empty,
the flame effect will shut OFF and
the LED's will blink continuously.
Follow these steps to refil the
tank.
CAUTION: Allow at least five
minutes for components to cool
before disassembling the unit to
refill.
1. Gently remove the media and
place it carefully on the ground.
2. Turn the On/Off switch to the
OFF position (O) (Figure 7A)
3. Remove the refill container by
lifting upwards and outwards.
4. Refill the container with tap
water.
!
NOTE: Normal tap water can
be used in the Opti-myst
as the tap water is not considered
to be hard water. In the event
your tap water is hard, you may
use softened water or distilled
water with ⅛ tsp. of salt (0.5 mL)
added to the water reservoir. (The
use of additional salt should only
be when you notice that the unit is
not producing mist as expected.)
5. Screw the cap back on, do not
6. Return the refill container to the
7. Turn the On/Off switch to the
8. Gently place the top tray back
If you do not intend on using
the unit for longer than 2 weeks,
empty and drain the unit of water,
and dry all of the water containing
components.
Transducer Replacement
After prolonged usage the ability
for the unit to produce mist may
become reduced. When this
occurs the replacement of the
transducer may be required.
This unit comes with additional
transducer(s), located within the
as long
®
unit, which can be installed when
this occurs.
!
that holds the transducer in place,
that needs to be released before
it can be removed.
overtighten.
sump, with the tank cap facing
down and the flat side of the
tank facing outward.
ON position ( I ). (Figure 7A)
into position.
NOTE: There is a small tab
17