Maintenance - Dimplex REL5 Owner’s Manual

Maintenance

Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
whole unit off and it will not come
back on without being reset. If the
button on the unit is pressed,
Er2 will be displayed on the unit.
It can be reset by turning the unit
off at the main disconnect panel
and waiting 5 minutes before
turning the unit back on.
CAUTION: If you need to
continuously reset the heater,
turn the unit off at the main
disconnect panel and call
technical support at:
1-888-346-7539.
20
Remote Control Battery
Replacement
To replace the Battery:
1. Slide battery cover open on
the remote control.
2. Correctly install one 3 Volt
(CR2032 [longer life] or
CR2025) Battery in the battery
holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area
 
WARNING: Disconnect power
and allow heater to cool before
attempting any maintenance or
cleaning to reduce the risk of
fire, electric shock or damage to
persons.
!
NOTE: The fireplace should
not be operated with an
accumulation of dust or dirt on
or in the unit, as this can cause
a build up of heat and eventual
damage. For this reason the
heater must be inspected
regularly, depending upon
conditions and at a minimum
yearly intervals.
www.dimplex.com