Emergency Button - EdilKamin INPELLET 54 Instalación Uso Y Mantenimiento

RESERVE WARNING
The INPELLET 54 is fitted with an electronic function that detects the residual quantity of pellets in the tank.
The detection system is integrated into the electronic board, allowing you to see how many hours and kg are left until
pellet exhaustion, at all times. For correct system function, it is important that the following procedure is followed during
the first ignition (by the Dealer).
1 st ignition/test by the Edilkamin authorised Dealer
Start-up must be carried out as prescribed by point 3.21 of standard UNI 10683.
This standard indicates the control operations to be carried out in situ, aimed at ascertaining correct system function.
Pellet reserve system
Before enabling the system, you need to load a sack of pellets into the tank and use the INPELLET 54 until the loaded
fuel has run out. This allows for a short system road test.
After this, the tank can be filled completely and the INPELLET 54 started up.
When running, at the time at which a whole 15 kg sack of pellets can be loaded, the display will show the word
"RESERVE" flashing.
At this point, after having poured in a sack of pellets, you need to 'inform' the memory that you have loaded 15 kg.
To do so, proceed as follows:
1. press the "M" key (for approximately 3-4 seconds) until the word "CLOCK" appears.
2. press the "+" key until the word "RESERVE" appears.
3. press the "M" key until the following screen appears,
Kg remaining in tank
then use the "+" key to take the figure (*) to the value equal to the Kg of pellets loaded (15 kg in the above example).
4. press the "M" key to confirm
5. press the key to exit.
After having completed the above procedure, after having consumed the 15 kg, the wording "RESERVE" will appear
flashing at intervals. After which the operation must be repeated, from point 1 to point 5.

EMERGENCY BUTTON

Should the remote control be broken, the basic functions can also be accessed by means of a red emergency button
located under the external hatch, on the left (see fig. 7).
Use a screwdriver to press the button once or more to enable the function desired:
1. A INPELLET 54 OFF
by pressing the red button for 2 seconds this turns on.
2. A INPELLET 54 ON
by pressing the red button for 2 seconds this turns off.
3. A INPELLET 54 ON
manual mode, by pressing the red button, you go from P1 to P3.
4. A INPELLET 54 ON
automatic mode, by pressing the red button, you go from 5°C to 30°C.
RADIO ANTENNA
INPELLET 54 dialogues with the remote control by means of radio waves. The radio signal is received by the radio con-
trol by means of a small antenna beneath the external hatch (see fig. 7). Should the signal sent from the remote control be
too weak for the control distance or other reason, the antenna can be removed from its housing by rotating it.
INSTRUCTIONS FOR USE
radio antenna
fig. 7
31
Kg loaded
emergency button
serial port